Industry News
Home / News Center / Industry News
The components of a small swing granulator

  A small swing granulator is a machine that develops wet powder or block like dry materials into the required particles. Its screen is made of metal wire mesh, which is easy to install and disassemble, and the tension can be adjusted. The main components of the machinery are enclosed within the machine body and are equipped with a lubrication system, ensuring smooth operation during the production process. The overall appearance of the machine is made of stainless steel plates. Compliance with GMP standards significantly improves the quality and economic efficiency of particles.

Let's take a look at the various components of a small swing granulator:

1. Subject

  The body of the aircraft is an independent rectangular column, with a closed bearing seat connected to the powder hopper. The powder hopper extends out of the machine body, and a V-shaped chassis is installed below it, which is wide and flat on the ground. Therefore, it must be installed below and can be placed indoors for use at will.

2. Particle manufacturing device

  The rotating drum is horizontally placed under the powder hopper, with bearing supports at the front and rear. It rotates in a reverse direction through the transmission of gear racks. The front bearing cover of the end face is movable, and during assembly and disassembly, as long as a wing nut is unscrewed, the bearing cover and the rotating drum can be pulled out. The two ends of the placed drum are made with convex square rings, which are embedded in the bearing chamber, so as to prevent oil stains from seeping into the powder and prevent it from sticking and blocking.

3. Gearbox

  Adopting worm gear transmission with a speed ratio of 1:12, the gearbox can store oil to ensure good gear lubrication and no noise. There is a mirror on the gearbox to observe the operation and oil storage. The outer end of the worm gear is equipped with an eccentric shaft to drive the gear rack to move back and forth.

4. Screen clamp tube

  The device is made of steel pipes on both sides of the rotating drum, with a long groove in the middle. The two ends of the screen mesh are embedded in the groove, and the flower shaped handwheel is rotated to wrap the screen mesh on the outer circle of the rotating drum. The handwheel is supported by gears, and the tension can be adjusted.

5. Motor frame

  When one bolt is firmly connected to the screw, the electric motor is installed on the iron plate. When the screw bolt is turned, the electric motor moves up and down to adjust the belt.

  In the field of chemicals, it is used as a wet powder to grind particles, which are dried and used for pressing tablets. It can also be crushed into blocks that coagulate during storage or clump during chemical processing. In the food industry, it is used to treat candies, sugar mixtures, malt and milk, and in other industries, such as ceramics, plastics, and other mixtures to form particles.

Previous Information:Introduction to the advantages of boiling granulation dryer
Next Information:Working principle of spray granulator dryer


Copyright © 2023 Jiangsu Shangjin Drying Technology Co., Ltd.   Support:JW WISDOM CUBIC

Hotline

+8615161118388